Search found 2 matches
- Sun, Aug 11 2013, 9:24PM
- Forum: Thermwood 3-Axis Machinery
- Topic: "Following error Z axis"
- Replies: 1
- Views: 5385
Re: "Following error Z axis"
Jason, If I remember correctly when this happen to us it was a lose connection on the encoder cable. Shut down the machine and check the encoder cable at the Z axis motor and on the servo drive in the control cabinet. Take them off and put them back on (this helps clean the pins to make a better con...
- Wed, Aug 17 2011, 5:26PM
- Forum: Thermwood 3-Axis Machinery
- Topic: How long can the Machine Run for?
- Replies: 18
- Views: 17814
Re: How long can the Machine Run for?
There should be no limit as long as you keep it maintained. Grease/oil when required and keep the filters on the A/C unit clean. We have run ours 24/7 without any problems. We routinely run 12-13 hour long programs, unload and load new material and start it again without any major problems. Clean th...