Thermwood / eCabinet Systems

Just loaded CN 5.41 and ran the first project. It appears that there is an issue with the Off Fall when the code is written. The off fall shifts in the positive X direction approximately 1" and it cuts into any parts that may be in its path. Reloaded CN 5.40 and issue corrected. I am using control ...

User Defined Moldings has my Vote

Has anyone had any success making shaker style doors or flat panel doors in the MDF section of the door editor. I have a customer that is interested in using a MDF flat panel door with a painted finish. Any help would be appreciated. Thanks
Joe

Mike
I am using the material thickness that is entered in the library. It appears that the dado is referenced from the cut edge of the panel not the face of edge banding.

Thanks for all the advice and help. I now can get the end panel with edge banding to graphically appear correct, but when I try to cut the cabinet on the cnc the end panel is flush with the deck, so when adding the banding the side extends past the deck by the thickness of the edge banding. I have ...

My question relates to the left or right end panel on a frame less upper cabinet. We use a veneered deck panel and require edge banding on the bottom edge of the left & right end panels. When adding the edge banding, the end panel is adjusted for size to allow for edge banding. But the joint (blind ...

Good idea Forrest count me in.

Joe

Ryan
Thanks I have found that the feed rate issue was moving from home to the G51 location and then the feed rate increased. I have cut my first rental program and it worked just fine.

Thanks
Joe

I am trying to run a rental program and it seams to be running a feed rate in inches and our machine is factory set for metric. Is there any fix or work around for this.
Thanks
Joe

Mark
We have the same issues with the order in which you enter the off fall.