Thermwood / eCabinet Systems

What you mean theres no \"EASY\" button haha

You guys are helpful as always, thanks again! I will give that a shot.

Kevin

Hi,

I would like to angle the front corner of a base cabinet (45 degrees about 3 inches wide).

I've searched around the construction settings, but have not found the secret to doing this.

Looking for some help to point me inthe right direction.

Thanks

Kevin

Hi Guys, Well all seems to be working fine today for what ever reason. Leo I did notice as you said that in the cabinet editor it did not show the dado, but after returning to the main editor the dado shows up. Going back into the shelf editor they then show up. All is good, thanks for the input eve...

Kerry, I will retrace my steps and double check, I have approached it with the following steps. Load cabinet Change constructions settings for a fixed shelf to full dado Go to shelf editor Click on the opening make sure the fixed shelf radio button is selected and the select \"Add Shelf\" ...

Mike,

Thanks for the help, attached is the HSF file.

Update on the problem, I tried to add a fixed shelf to other existing cabinets and have had the same results, no dados. I am guessing I may have changed a global setting I am unaware of??

Thanks

Kevin

Hi All, I am embarrased to ask, because I have done this hundered of times but... For some reason I am having some difficulty adding a fixed shelf to a cabinet. I have specified the shelf have full dados on both the left and right sides, however when I add this to the cabinet it does not include the...

Dan,

As always you have been very helpful, a 1000 thank yous...again

Kevin

Hi All, In the past when I wanted to see a particular cabinet in a different material, I have gone in to setting and preferences and updated both my sheet stock and board stock material images, and then loaded the cabinet. Once the cabinet loads all the material changes and all was good. Today I hav...

Hi Joe, Yep DeSoto is just West of Kansas City about 5 miles. I like it. My cabinet is very much a work in progress. I am still struggling on the learning curve with the SW, but slowly making progress. I planned on the cabinet being a face frame with a single door on the angled surface, and yes a to...

Guys,

Thanks for the input. I went with the pony wall method due to electrical concerns. It worked out fine.

I appreciate the help.
Kevin

Here is a quick update on my progress, (minus a few hairs pulled) I used the part editor to cut the toekicks, but when I try to change the depth of the right and left backs (this started from a standard corner cabinet) I get a message indicating this will result in an unstable cabinet. Current depth...

Hi All, I would like to create an outside corner base cabinet with an angled front and am having some difficulty. I did not see one in the standard cabinets so I started with an inside corner cabinet and have been attempting to modify it, but am not certain how to create the toe kicks on the \"...

All, I am looking for some guidance in creating my first breakfast bar. I would like a basic kitchen island, but add a raised bar on the backside. I am thinking I need to create a pony wall on the back side and save the assembly. Is there a more preferred method, or am I on the right track? Thanks K...

you guys are killing me here.. :) I love it. Actually I'm just happy to know I wasn't overlooking something simple for once. WOW All kidding aside, having this feature would be an invaluable sales tool. Instant gratification of a customer certainly helps with a deposit check. Since I am on the lower...

Hi All, On occasion I have a client that would like to see what an assembly would look like with a different finish or material, say from Oak to Maple. I typically take a laptop to present their cabinets to them in a room layout. When working with an assembly or even an individual cabinet, can I qui...