Thermwood / eCabinet Systems

Hey there,
I am having a little trouble hingeing a door over a partition i have tried putting a neg inset on the hinge side to place the door over the partition but it does not change anything, I was wondering if there is a way to do so, or can i correct anything.
Cheers Tim

Hey, I have just installed the latest control nest 5.43. The first job i went to load will not nest, an error -Rnest appears and then the progam just freezes and the whole process just stops i have tried nesting just a couple of parts and different job files, I did resart the computer but that was k...

Hey, I am having a bit of trouble with some dados in 32mm MDF, the dados are 7mm depth an 32mm in width an it is trying to find a tool that is between 16mm diamater and 32mm diamater to do it.I think it is trying to do it in a sweep up and back. But i want to use a 12mm cutter and do it in a few pas...

Hi There We are having a small problem with Control nest, If we have a cabinet say 866 height and 1300 long it will not nest the backs or the shelves, when you read the error it has nested it across the sheet rather than down the length. We use 16mm Melemine sheet size 3600x1200 and it always nests ...

Hi I have being playing around a little with the Display of a Kitchen an i cant get a sink to snap onto the bench top or change the size and mount height. As well i have tryed doin the same with a micro and same problem if anyone could help would be great! And is there a way to update the Display Ob...

Try this the problem seems to be in the first drill code on sheet three

Hi
We are having a prodlem with error code randomly in jobs when the job gets nested there are no problems, the drill bank trys to drill down while bein in home position on the third sheet not sure if it is a part on the sheet or the machine has not homed properley.
Thanks
Tim

Hi We are having a promblem with a (Error Code 3050 X axis out of bounds) which pops up while cutting it happens about 300mm from the end of the table, then the machine stops an we skip one line and it is right again. When we write the code there is no Error found, I have checked the table settings ...

We have grained drawer fronts that are not grouping 1,2,3 on e-cabinets but they keep nesting 1,3,2 on thermwood. why would it be doing that if could help would be great
Thanks Tim

Yes it is the same, we can do it manually in part editor but it just takes longer it just would have been good to save that hole pattern to our batch cabinets, thats ok
thanks Tim

Hi There
We where wonderin if it is possible to save 5mm through holes in our checks, so when we assemble Cabinets we dont have to drill them manually!
Thanks Tim

hello, I am getting a error when writing cnc code. once i have writin the code i have bein back an read it and it says 'Tool size between 33mm an 16mm not set up in tooling i know its for the dados. i have set up the material in the tooling an cant understand why the error is still appearing. t woul...

I was just wondering if it is possible to put shelves on a 45 in a cabinet

no not that i know of, the job file is there and it loads up just like normal but you just cant see any of the job and it says room not existing, then i just sent it through to the thermwood and it nested all the parts!all need to do is change the sizes in e-cabinets

G'day we are having a problem with one of our job files when you load it! The job seems to be losding but the room does not exist so you cant alter any cabinets which we want to do.I have nested the job an all the parts are nesting an i cant understand why? If you could help it would be much appreci...