Thermwood / eCabinet Systems

Thanks for the info Jeremy. We will get it fixed.

If you have an issue with the ShopBot Link, you may contact Thermwood.

Special Note: If you utilize a network path for your user data, please refer to the notice titled User Data Network Path on the Install/Update page.

http://www.ecabinetsystems.com/ecabinet ... pdates.htm

Special Note: If you utilize a network path for your user data, please refer to the notice titled User Data Network Path on the Install/Update page.

http://www.ecabinetsystems.com/ecabinet ... pdates.htm

http://www.thermwood.com/updates_control_nesting_home.htm NOTE: There is an unsigned version of the update installer available on the update page. We have found that older XP versions are having difficulty running a certified executable. If you are experiencing failures with the installer you can tr...

http://www.thermwood.com/updates_control_nesting_home.htm NOTE: There is an unsigned version of the update installer available on the update page. We have found that older XP versions are having difficulty running a certified executable. If you are experiencing failures with the installer you can tr...

Hi Thomas. The group combo box is greyed out when accessing the Nesting Parameters from the Settings dialog. The group setting is determined on the Settings dialog when using that method to access Nesting Parameters. When using the Edit menu to access the Nesting Parameters, the group combo box is e...

Just a note. You might get some errors for "appropriate start point not found". They should not hurt your result. Simply click OK on them.

Control Nesting has to iterate through all the entities to piece together an operation. I found some bad geometry at spots on your dxf. I modified the drawing by putting in a few long lines and correcting the non-connected spots with bad geometry. I also segregated each chain for it's own layer. It ...

We've found the issue. It will be fixed in the next update. Thanks for the message!

Sorry for the trouble Tim. We've reproduced the problem and will get it resolved. I did notice if you nest just those 4 doors you get the desired result. This can help you get the job done if needed.

Good idea Brad. We'll make the change.

Sorry for the confusion on this Thomas. We misspoke on this issue. Nothing has been altered for feed speed entries except for min feed rate in Settings. The problem that initially occurred was on a machine that is in Imperial and Control Nesting is in Metric. Min feed rate was not being obeyed. The ...

You might be missing a file or have a bad file that is needed for this process. Unzip the attachment and place zigaba.twt1 in the following directory.

c:\Profile Modeler\TWD

Thank you for the heads up Thomas. We have it updated now.