Thermwood / eCabinet Systems

Ok, I will see if I can find a corner base cabinet. Seems odd that you would not be able to change the type.

Is there a way to change from Upper to Base?

here you go.

Yeah, just tried a new wall with just that single cabinet, and it shows up everywhere except the countertop page. I have no clue.

I thought about that, but does not work either. I have tried just about everything, including shutting down the software and re-starting it. Nothing seems to work.

I have a drawing where I have a corner cabinet that has been associated to the main wall #2, but will not show in the countertop page. It does show in all other pages, just not in the countertop page. Any ideas?

Attached is a picture. I would like the countertop to go around the corner.

I have a need to create a curved wall for a client. I have search the forum and have found one way to accomplish this, but I can not figure it out. Can someone help me with this, with some detailed instructions. I have built a display cube and have it in the parts editor, but unable to figure out ...

Tim, thanks. exactly what i was looking for.

Does anyone have a sample cabinet that I can load into my system? I can not figure out how to build this cabinet with Ecabs.

Yes, this cabinet will sit in the corner. So it will be a five sided cabinet with the face frame on an angle.

Actually it's happening in multiple places.

System crashes if I selection Door/Drawer Selection. Has worked in the past, just not working now. Any suggestions?

Kerry, that fixed the problem. Thanks for the help with this. Frustrating to say the least.

Kerry, the file is attached.

Carmen, both Left & Right are set like they should, but still not the correct depth.

Scott, checked the settings, and both are marked side flush.

Kerry, not sure how to post the cabinet for your viewing.

I did manage to get around it, by changing the Cabinet Depth to 12.375, but that does not seem correct?

I'm working with upper cabinets, which in this case are 12" deep. That measurement should be from the back of the cabinet to the front of the face frame. I dado my 1/2" back's into each side which makes everything flush on the back. Then the sides are dado'd into the face frame. My cabinet dimension ...