Search found 3 matches
- Tue, Nov 05 2013, 3:11AM
- Forum: Thermwood 3-Axis Machinery
- Topic: Used C40 setup problems
- Replies: 3
- Views: 5828
Re: Used C40 setup problems
Thank you, Brad, I have a test on the table by mimic a cut on the same dimension sheet. Only smaller by 4mm at each axis. And read from graphic, the cutting is shifting to x+ and y+ by 15mm. So the question is what shall I adjust for the home position. There is a home offset mentioned in manual but ...
- Thu, Oct 31 2013, 3:07AM
- Forum: Thermwood 3-Axis Machinery
- Topic: Used C40 setup problems
- Replies: 3
- Views: 5828
Re: Used C40 setup problems
Actually, the cutting on Y axis is shifted upwards by 1 inch. not enlarged.
do I have to adjust the fixture offset? the bed dimensions are right.
it is new to me. a bid confusing.
do I have to adjust the fixture offset? the bed dimensions are right.
it is new to me. a bid confusing.
- Wed, Oct 30 2013, 10:05PM
- Forum: Thermwood 3-Axis Machinery
- Topic: Used C40 setup problems
- Replies: 3
- Views: 5828
Used C40 setup problems
Hi, I have just bought a second hand C40. After installation, there are several problems, First, cutting on y axis was over by 1 inch. Then I tried to normalize all axis without c marker realigning, on Y the encoder counts home to cmarker is 005455, home to ramp 009464. x the encoder counts home to ...