Search found 3 matches
- Fri, Dec 13 2013, 10:15AM
- Forum: Thermwood 3-Axis Machinery
- Topic: g60l1 code
- Replies: 4
- Views: 5809
Re: g60l1 code
thanks for the help. Like Pete at Thermwood said to me ,problems are usually user error. It wasn't a G60L1 code it was a M60L1 code. I had settings wrong in the settings page of control nesting. Everything is good.
- Thu, Dec 12 2013, 10:16PM
- Forum: Thermwood 3-Axis Machinery
- Topic: g60l1 code
- Replies: 4
- Views: 5809
Re: g60l1 code
Hi, Your right the G60l1 checks input Switch 1 ( my pop up pins) is on. Thing is At this point they are off. Machine locks up. I block stop, press TAB, change to G60l-1 (check Input 1 is off which they are) press enter Then cycle start. There is no M00 in the code This is right at the beginning of t...
- Thu, Dec 12 2013, 3:29PM
- Forum: Thermwood 3-Axis Machinery
- Topic: g60l1 code
- Replies: 4
- Views: 5809
g60l1 code
Hi everyone, I just got my cs 43 running. When I use controle nesting to generate cnc code and then run it, the sequence stops on a G60L1 code and will not move to the next command unless I either delete the line or change it to G60L-1. then cycle start to continue. Does anybody know why? Thanks, St...