Search found 3 matches

by Brian Kutzke
Wed, Jan 15 2014, 1:27AM
Forum: Thermwood 3-Axis Machinery
Topic: Z axis issue
Replies: 2
Views: 1402

Re: Z axis issue

Ended up being the 12V 1A pico fuse on the motherboard. Replaced the +12V, then the -12V fried 3 days later. I suggest if anybody else runs into this, that they buy more than 1 fuse. I did just as a precaution if I screwed up installing it, and was lucky to have the second one.
by Brian Kutzke
Thu, Dec 19 2013, 7:46PM
Forum: Thermwood 3-Axis Machinery
Topic: Vacuum Pump for my C53
Replies: 7
Views: 3174

Re: Vacuum Pump for my C53

We have been looking at purchasing another pump as well. What is a good CFM combination? Our current small pump only pulls 56 CFM...
by Brian Kutzke
Thu, Dec 19 2013, 6:53PM
Forum: Thermwood 3-Axis Machinery
Topic: Z axis issue
Replies: 2
Views: 1402

Z axis issue

Hello, We were running our C40 today and the operator hit the E-stop in the middle of a M99 operation. Now the machine will not home, and it is giving an error message of "Z axis has exceeded following error limit" I have tried powering down and checking all the z axis connections. No issu...

Go to advanced search