Thermwood / eCabinet Systems

Recently when I choose lock dado I am no longer getting the holes for the rta fitting. Any idea what could be the cause? All was fine in the same job until the last few cabinets.

Thank you Scott.
I had some success, I had to delete and reinstall the doors to get the results. I did not have any luck changing globally.
Tom

Thank you Scott. That is it.

How can I stop in the middle of a job then start up where I left off.
Say I have a 20 sheet job and only get 12 cut before the end of the day and want to finish the last 8 sheets the next day. How would I do that?
Also how do I stop cutting on a sheet and then resume cutting?
Tom Peckham

The hole depth for my blum hinge plates are barely perceptible. I have edited them in the hardware editor. in the editor they show depth in the 3d view and show the proper negative depth in the description. in the cabinet editor the 3d view shows them barely there. in the nesting view the part descr...