Search found 4 matches

by Jim Augustine
Wed, Feb 14 2018, 7:04AM
Forum: eCabinet Systems Software
Topic: Nest Diagram Inefficiency
Replies: 7
Views: 1146

Re: Nest Diagram Inefficiency

Clint,

Thank you for taking a look at this. Attached is the cabinet file

Miter stand cabinet_ PH.hsf
(1004.02 KiB) Downloaded 43 times
Miter stand cabinet_ PH.jpg
Miter stand cabinet_ PH.jpg (9.4 KiB) Viewed 1052 times
by Jim Augustine
Mon, Feb 12 2018, 8:53PM
Forum: eCabinet Systems Software
Topic: Nest Diagram Inefficiency
Replies: 7
Views: 1146

Re: Nest Diagram Inefficiency

Mark,

Thanks for sharing your experiences. I have a 30 sheet job coming up which is why I wrote this post and my concern for the nesting efficiency. I'll just go with it and not worry about it.
by Jim Augustine
Fri, Feb 09 2018, 8:53PM
Forum: eCabinet Systems Software
Topic: Nest Diagram Inefficiency
Replies: 7
Views: 1146

Re: Nest Diagram Inefficiency

Thank you for the suggestions. I changed the collar to 1/8 and 0 on seperate nests both horizontal and vertical - see attached, the grain has been set to "no" on all nests. Still get the same diagram as orignally posted. I am using the "Cut Line" nest type as this cabinet will be...
by Jim Augustine
Thu, Feb 08 2018, 4:23PM
Forum: eCabinet Systems Software
Topic: Nest Diagram Inefficiency
Replies: 7
Views: 1146

Nest Diagram Inefficiency

Just started using eCabinets 5 weeks ago and have run into this issue will performing a nest diagram (see attached). This is a cut line diagram as I am using a slider cut the parts for this cabinet. I know the second sheet of Melanine is not need since the only board cut from it will easily fit hori...

Go to advanced search