Search found 352 matches

by Daniel Vonderheide
Wed, Feb 07 2007, 9:57AM
Forum: Thermwood 3-Axis Machinery
Topic: DXFs and grain direction
Replies: 2
Views: 506

The grain on the dxf files follow the x axis of the drawing, so when you draw your dxf file in your cad system, you need to know how the grain will lay on the part and draw the piece so the grain is following the x axis. When you load the dxf into the Control Nesting software, it asks you to select ...
by Daniel Vonderheide
Tue, Jan 30 2007, 3:45PM
Forum: Thermwood 3-Axis Machinery
Topic: problem with double-pass outlines
Replies: 2
Views: 585

Mark, Your issue does sound like the one Forrest describes in his post. The way to test this is run a small piece using a conv. cut and then cut the same piece using a climb cut. If the ledge shows up on the conv. cut and not the climb cut, then we are looking at the same issue Forrest described. If...
by Daniel Vonderheide
Tue, Jan 30 2007, 3:10PM
Forum: Thermwood 3-Axis Machinery
Topic: Dovetail drawer tool for baltic birch
Replies: 1
Views: 485

Dan,
Both tools will work for your material but I would go with the 1/2 bit. This will give you the flexability to use thicker or thinner material to a certain extent. Most of the customers I have worked with were using the 1/2 tool on 5/8 material with great success.
by Daniel Vonderheide
Thu, Jan 25 2007, 10:58AM
Forum: eCabinet Systems Software
Topic: Not Funny - Resizing Problems
Replies: 10
Views: 1830

leo Attached is a cabinet that is almost exactly what you want. I offset the toe kick and then took it into the part editor and put a simple cut in it. I then took it into the constraint manager and constrained the cut. Look over the construction settings and let me know if you have any questions. 1...
by Daniel Vonderheide
Tue, Jan 16 2007, 3:30PM
Forum: eCabinet Systems Software
Topic: Diameter of tool didnt work for a rout operation on deck.
Replies: 4
Views: 985

Steve, could you e-mail me the twd file and the esj file for this cabinet? Also if you could create the export.cab file and send that along we can start working on your issue. program@thermwood.com
by Daniel Vonderheide
Tue, Jan 16 2007, 9:42AM
Forum: Thermwood 3-Axis Machinery
Topic: tabs
Replies: 1
Views: 504

Jim, what version of Control Nesting are you using? It sounds like all of your settings are correct. Please give me a call (1-800-221-3865 EXT.245) and we'll try to get this figured out for you. Thank you.
by Daniel Vonderheide
Thu, Dec 07 2006, 10:18AM
Forum: Thermwood 3-Axis Machinery
Topic: Hinge hole problems Again!!!
Replies: 2
Views: 558

Nick, could you please create the controlnest508.cab file using the export button at the bottom of the control nesting screen and then send me that f and the twd file, I'll start looking into it. Send them to program@thermwood.com

Thanks

Go to advanced search