Thermwood / eCabinet Systems

Has anyone ever made a fold together style veneer box where you would V-Groove 45 degree bevels inbetween bottom and sides leaving a thin skin to just glue and fold over creating a mitered looking box????

Ok So it moves now to the right end of the field but being that it is Working from the 0.0 Point it goes off the table????? Heres some lines and it i think would have to reference 0.0 As the center of the work piece which would be 18" Overall so 9" center...Now How do i shift in the x,y co...

ah that makes sense...thats what i get for writing this at 11am in the morning on a Sunday haha...I remember him saying thats what it was for in a post before lol

If i put the G901 in and the prog what could be not setup with it? What would be a result perhaps?(Dont want to wreck the machine really lol) So if i wrote it as : M98PSTRTTIME.SUBL1 M48 G90 SET WASTEBOARD=0.2550 G901 SET ZSHIFT=0.7500+WASTEBOARD SET XSHIFT=120.0000 (We have a 5x10 Table) SET YSHIFT...

M98PSTRTTIME.SUBL1
M48
G90
SET ZSHIFT = 0.7500+ what i figure my waste board is
(Enter Material Thickness) This material thickness is left the same???
SET XSHIFT=120.0000
SET YSHIFT=49.0000
G09F8
G52L1
T1 M3
S15000

So if i wrote code like this would this work to shift the axis???

M98PSTRTTIME.SUBL1
M48
G90
SET ZSHIFT = 0.867
(Enter Material Thickness)
SET XSHIFT=120.0000
SET YSHIFT=49.0000
G09F8
G52L1
T1 M3
S15000

Ok so my question is how do i change my X and Y Reference points on my machine as it is at the outter egde of home...As X=0 Y=0 at the home position of the machine but my machine references the pins at x=120 and y=49... do i have to go through each line and change the co ordinates?????

would this be something we could look forward to for newer eCabinet designing??? As this would help in setting of glides automatically instead of using the jigs supplied for certain companies...

Hey So i want to apply a hole pattern to the bottom of a box bottom for preset holes for where the glides will go on a meta box so it will automatically shift with size changes on parts...is this possible???

Ok Thanks that worked perfect now I nest from the x=97 y=49 Side of my machine that being the x=0 y=0 thing you were mentioning? So if i wanna reference from my pins i would put the x97 y49 correct? Also Tool changing on it is set up to use my surfacing tool With the T1 M3 So would writing the code ...

Ok I will add that in after the M98 Line....But how do i actually put this into the Supercontrol without typing line for line???? What format must it be in? can i load this text in somehow???/

Heres the file! in text i think now for it

Ok the big question...have a emblem i'm wanting to run. This is the program i had been given to try it out on now how do i get it to run on my machine...what blanks do i have to fill in and how do i upload to the Thermwood super control

just change the .txt to .nc if u wanna see how i c it:P

hey sent ya a email, thanks

Hey i wanna make a Edmonton Oilers Emblem how do i go about making this or does someone have one they are willing to share....Dxf or whatever will work....Would like it for 5/8\"...3/4\" and 22mm Material...any help would be awesome!!