Thermwood / eCabinet Systems

I think you can take that as a "no" Neville, but whilst we wait I had an idea for a feature that would be useful. I encountered a problem whereby I was nesting material for which i did not have tooling setup, therefore each pocketing operation came up with an error requiring me to stand at...

Thanks Joe I will check it out. I was under the impression all this time that associations were job specific.

Hi Paul how are things in Pretoria. This sounds like typical South African bad attitude and service. Comes from years of closed markets monopolies and lack of competition, I would not say it was Ford per se, you would not get this in the States where they understand customer service.

Something for the programmers to look into... I just did a job where when I machined it I noticed that the hinge holes were drilled 20mm of the edge of the doors instead of my normal 5mm. I looked back into the eCabs job and saw that the hole pattern had changed to this offset, even though I had des...

Nope!

Thanks Bryan got it! 63Megs for a time update, incredible!!!

Started eCabs this morning and got the message "eCabs will expire in 9 days" Whats that guys?

Ja but we knew what he meant Dean!!! " Can you " I mean how much clearer do you need to be, Phhhhtt!

Gary effectively you can if you create a standard unit with those settings and then save it. Any cab created from it will have your standard dado settings from then on.

It may well spool a seperate file per page but I have never noticed a slow down in printing and the pages spew out one after the other like any document.

HI Kerry. I have run eCabs on many different system and they all printed at the correct speed and never manifest the problem you describe. So as unhelpful as it seems the problem lies somewhere in your particular installation or system.

Kerry you certainly surprised me with this one so I just ran a quick test. It sends all pages to my printer on my system so maybe it is your printer memory or settings?

Damn!! the 22nd has come and gone. Thought v6 would have been launched to upstage Microsoft!!

Gary it does work, just go into the construction settings of the part in the stretcher editor and just make sure that "Top" is set to dado/ blind dado.

Cant see why you should have any problems with consistency of finish using NC's (1K) Poly-actrathanes (2K) or AC's. I have sprayed a range of deep colours, reds & blues included without variation in tone.