Thermwood / eCabinet Systems

I work at a place that uses e-cabs now(no I work on the floor) however they asked me to look at a display panel they were trying to cut... Basically a panel with a 1/4x 3/8 dadoe off one long side...well when I used the part editor everything went well however when we went to nest it no dadoe was pr...

I work at a place that uses e-cabs now(no I work on the floor) however they asked me to look at a display panel they were trying to cut... Basically a panel with a 1/4x 3/8 dadoe off one long side...well when I used the part editor everything went well however when we went to nest it no dadoe was pr...

You mean like doing hole patterns for hardware?

Gordon, The feature allowing us to export to excell was a pleaseant surprise for me.... The reason I stated using e-cabs was for the cut lists.. I do not own a CNC myself and therefore relied on the cutlist to order stock..It has been great... When I use production sharing the cutlist was a great to...

That is a clever solution....

Can we make the DXF file in e-cabs?

Do you do that with Blind Dadoes also? If you do why not just staple em?

Very cool

Mine loads the same way it has for the past year and a half....not in an imported images file but rather in the stock images under \"Red Oak\"

Dan, The last place I was at had the same issue, the only predrilled locations were the deck and the top....hence the time waster that it was... They used MicroVellum So it would work for the decks and the tops correct? I wouldn't know cause I use the blind dadoes and staple right through...Shiners ...

Not doubting anybodies integrity here Dan....

I have had simple brochures made for my company I am well aware of the cost...

What is the timeline like right now? 1-2 months?

Ray, I just left a company wher they insited on using screws through the dadoes.....the extra time was a nightnmare. Cause the CNC will not drill the Horizontal member(it will but apparently it is not efficient) so you gotta go through and pilot hole manually each time even if the sides are predrill...

Michael, I run the number with e-cabs pricing; and the hardware usually is a little more expensive than what I pay...and I bid on this price. If the project is a sale then I am a little ahead of the game... On another note if you call -e-cabs they may be able to get you case lot prices if you are or...

DAn that sounds good...

Will you include any of the furniture network products in there?

I will go through my library and see what I can come up with, what is the price range you are talking about(per book)....

Let's say I want 10...

Thanks

is there a way in V5 to set a system hole pattern?

Particularly reference \"Blum process 32\".....

Incorprating this into my library would be great...

I did it before by strategically placing an adjutable shelf, but it was time consuming...

Thanks

Very cool, After tons of reading on the \"traditional\" way to make these and then reading some stuff on CNC production of molding I have a couple of questions: How hard is it to hold the piece down on the CNC while cutting? Is this a production possibility or is it a less expensive way to...

Don't know how that happened

I think plyboo maybe a cost effective way to produce lots of drawer parts on a sheet, and have thatreal wood look...