Thermwood / eCabinet Systems

Thanks Scott, I will see if I can find that repair tool.

What if I uninstall ecabinets then re-install? Will I need a whole new registration code?

Thank you very much for the response Scott. Yes, I have always been aware of that. But its more than that, much more. I'm not wanting to make a 3.5" wall, I used to be able to place the cursor anywhere on the grid, click and drag out the wall to any size. Now when I click and drag it makes a 4&...

I cannot make a wall in the custom layout room. When I click the mouse to start a wall I get a message with title " Wall too short" then the words, "Wall lengths must be greater to or equal than the thickness of the wall. The wall will be set to the current wall thickness" Click ...

Rick, I had the path going to the external drive. I think there was a problem when it backed up. I did go and back up ecabinets from the old pc on a flash drive. This worked and ecabinets is now restored to where I can use it. It did say that that it was a partial restore so I assume the proposal wr...

Rick, thank you very much for your help! Something is still not right. When I use ecabinets all of my saved folders for assemblies and cabinets are missing. When I go to the door and drawer editor all of my saved doors and drawer fronts are missing. And, my materials are all gone as well. I did find...

Good instructions sir!

Rick, I am not sure how to do that.

I just brought home a new PC and cant get my files to restore. I downloaded the latest version of ecabs from the Thermwood site. My files are on a external hard drive and I have selected that as the location. Here, is the error I get, Ecabinets systems restore was not successful. Please refer to the...

Thank you Dennis, I will play around with that as well.

Jeff C

I found a way to do it, kind of. When you are in the door/drawer editor, choose to load a double door but set the door gap to negative 2/3-8". I have me stiles set at 2 3/8". The doors overlap each other but when rendered looks pretty good. You have to remember it will add an extra stile t...

Is there a way to make two and four panel doors? Customers are wanting the mission doors with the center stile, two panel design. It would be nice to be able to show them how they look. Here is a photo of what they want. http://www.crown-point.com/arts-and-crafts/images2/large/16-large-04.jpg Thank ...

Well, I ran my window washer and restarted the computer. It worked! It is back to saving my jobs and life goes on, back out to the shop. Thank you everyone, its seems to be resolved for now.

Jeff C

10.4 MB

OK, I went to the ecabinets folder, selected the job file, right clicked it and selected to send to a zipped ( compressed) folder. Then from the post a reply screen I used the upload attachment tab, found the zipped folder then tried to attach it but after watching it load for about two minutes it b...