Thermwood / eCabinet Systems

Theres always the duty free shops at the airport...Or do they not have them any more(I haven't flown civilian since before 9/11)...

As we use several sizes of material on our table I cover the "open area"with vinyl templating material"with a few corian blocks to keep it from curling.When the vacuum is on this gets sucked down as well reducing any bleed.It's easily removable plus I can fold or roll it to fit as mat...

Unfortunately sometimes unpopular laws are going to get passed before elections(which politicians often race to do before the people make the choice for them), which might mean it could be too late.Our system although in the hands of the people is still not perfect,especially when voters are only ab...

We do almost exclusively solid surface on our machine,everything from countertops to boxes even signs.We've even had a guy bring in some marine grade plywood and a program to replace the deck of his boat!

Our company uses them all the time for our countertops,they are one of the best tools for accurately recording wall scribe.Before we used the lasers we were constantly having to scribe our tops in the field(often in the customers driveway with a belt sander.)having to bring them in and out of the ho...

I was wondering is perhaps in a future update there would be any way to show on the control nesting window where the router is going to ramp in,maybe a colored line. This way we could rotate the pieces accordingly so as not to start on a seam(for us who seam pieces together) sometimes it just has th...

We get it too where the router ramps into the cut(we are a solid surfaces shop and more often or not this seems to be on a seam).It also happened alot when we first got the machine until we switched from a climb to a conventional cut(in settings on control nesting).

Too bad you were not coming next weekend instead of in september,the Syracuse Nationals is happening,it's one of the largest car shows in the nation,this year Adam West is going to be there with the original Batmobile!!!Alot of car clubs hold "runs" everyweekend,finding a car show shouldn'...

We have a new high end housing development being put in five miles up our road,rumour had it that they are actually going to run broadband internet(we can only get dialup now.) I've actually accomplished more reading due to the changeover(books 1-7 of the Wheel of Time series) and my garden has fewe...

Went through the hullabaloo as if the x axis belt had jumped a tooth...made some phone calls...never thought to check if proximity sensor was working, it wasn't in fact it was broken at the tip.A few hours of messing around for a simple fix if only I had thought...

the following(not 0.00)were in theservo box(I got a little carried away with the zeroes):
axis1 error -.5576 gantry skew -.0036
axis 2 error.0331

This morning when I started our thermwood I went to home it out and the emergency stop kicked in with the following error message: gantry skewing exceeds it's limit bring up servo box for skew update . the servo screen GAIN FFWD FOLLOWING ERROR GANTRY SKEWING CMARK axis1 .45 10 -0.000 -0.000 0.000 a...

ditto on the scotchbrite

We have the same problem,almost on a daily basis now that the humidity of summer is here.Is there some way to prevent the rust on the toolholder,I searched but could not find a clear solution.

We has the same issue when we first got our machine,I might be wrong but isn't tool length the total cutting length of the tool,for example we have a 3/8" onsrud bit total length is 3 5/8" including shaft but only 1 1/2" is actually used for cutting (I use a scale rule to measure by h...