Thermwood / eCabinet Systems

I answered you on the eCabinets Forum below...

http://www.thermwood.com/forums/viewtopic.php?t=662

As far as I know, this cannot be done yet.

To use the outline tool ONLY for the perimeter, make sure that tool is NOT in the Operations Setup. If you want to use it for everything except holes, then it SHOULD be in the Operation Tool(s) Setup but not checked for Drill or Interpolate;

I'm gonna have to hang out somewhere else, you all are too old for me. Ha! Just kidding! 29 here.

This could be a result from loading a Left hand-tool instead of the normal Right-hand tool, running the spindle in reverse, dullness, or the tooling type. Tooling types that could cause this are downspirals and 2-flute compression tools as these tools do not allow the material to leave the hole, cau...