Thermwood / eCabinet Systems

How would I get the front piece to extend the width of the unit? (In other words, have the side pieces die in to the back of the front piece?) The front is set up as a stretcher.

Thanks for the help, guys. I was misinterpreting the 'front width' to be the width of the cabinet opening, not the overall front width of the cabinet. I added the setbacks for the top and deck, and have the cabinet I'm after. Thanks again, I'm glad to be able to add this to my library. I was putting...

Dan,

I'm not completely clear on the terminology. The cabinet would come out of the corner 610mm in each direction.

I'm trying to set this cabinet up to be 610mm wide (across both backs), have the each of the actual cabinet sides be 304mm, and have a 406mm front opening. No matter what I try I can't seem to get these dimensions to work out on the cabinet. (I've put a 19mm inset on the sides to get them to cutlist...

Thanks again Kerry. I played around with that one quite a bit, and could not figure out what was going on.

Very easy, thanks very much for the help.

I'm setting my right and left depth at 304mm, but the actual size of the sides ends up at 324. I had thought that the right and left depth of the cabinet woyuld match the width of the right and left sides?

Nat

Is there a way to change the door material, aside from redoing the doors?

Wasn't able to figure out how (if possible?) to remove the 45 degree clip on the back of this corner cabinet. Is there a way to do it

Found the standard cabinets on my other computer. I think I must have deleted that folder on my main design computer, but have now pulled it in from the other.

Thanks.

Kerry,

Where do I find the 'Standard Corner Cabinets'? Are they in one of the downloadable libraries?

Thanks Dan.

I'm trying to design a 45 degree corner cabinet, and have seen mention of a 'corner settings' tab in the Cabinet Editor. I can't seem to find it. Has it been removed, or do I have it turned off, or...?

Thanks. Foolishly, I was using an image without a grain pattern for the door and drawer front material. Once I changed to an image with grain, I was able see fairly quickly what I was doing wrong.

I keep having odd materials surface when I try to load cabinets into the the cabinet editor. I get the 'material not found' error. It's the same material each time, but on different cabinets. I don't know where it's coming from, its not a material that I have used. How do I eliminate this? Thanks.

Dan,

Thanks very much for taking the time to post. Sorry not to have mentioned that I was using the SB Link, I didn't realize that it would factor in.

Nat