Thermwood / eCabinet Systems

Thanks Kerry, that did it. -Nat

I may not be going about this right, but I brought the display cube and cabinet together into the Cabinet Editor. The screenshot shows as far as I was able to get. My plan was to use the 'Align Items' feature. I was able to select a node on the display cube, but not on the cabinet (trying for the up...

Thanks Kerry, I'll give that a try. (No doubt more questions to follow...) -Nat

On cabinet with a sloped top, is there a way to have the counter follow the slope? I've attached a screenshot of what I came up with, using the Countertop Editor. Sorry for the extremely basic drawing, I rarely use this area of the software (or the Countertop Editor...) Thanks.

My error. Found the answer here:

http://www.thermwood.com/forums/viewtop ... ent#p35560

On the attached cabinet, I add my drawer front at a height of 157mm/ 6mm top reveal. When I hover the cursor over the newly added drawer front, it shows a height of 157.16mm. Changing the drawer front style from TW-10 to slab seems to eliminate the problem, but does anyone know why this is happening...

Jim, Increasing the depth of the holes should get them to show up on your cabinet. You'll have to play around with the entered depth to get the actual dilled depth that you're looking for. Once the holes do show up, the depth shown in the ecabinets nest diagrams should be the depth that you end up w...

Hi Rick,

I am primarily putting together jobs in Batch, and renaming the cabinets there. I was hoping to be able to have these names appear on the sheet printouts, as I use these names to number my cabinets.

Nat

In the part list below the nest diagram, is there a way to print the cabinet name, rather than the cabinet number? I'm using the SB Link, which may or may not be relevant. Once I'm done entering a job, the cabinet numbers rarely match the actual order/position of the cabinets in the room. I've resor...

Nevermind, just stumbled upon it. 'Corner Gap'.

How do I delete the small flat 'clip' that shows up on the back of this cabinet?

John, I think the only place that you can do what you're asking to do, is in the Custom Layout area. Select the cabinet(s) you want to change the doors/drawer fronts on, Right Click >'Adjust Cabinet Features' > 'Change > 'Doors' or 'Drawer Fronts"... You'll lose any part editor cuts you've made...

Thanks Nick,

I did try that, but will try it again.

This is the only cabinet that I use this hinge on, so if reapplying the hole pattern doesn't fix it, I could cheat the depth of the hole pattern, so that the actual drilling depth is correct.

On the attached 45 degree wall cabinet, the holes for the hinge plate screws are showing up (and drilling) at a depth of 3.04mm. The hole pattern that generates them has their depth set at 12.5mm. Have I got another setting off that's causing this? Thanks.

Would it be possible for the link to save 'added sheets' that have been entered manually? More than once I've needed to close the program in the middle of cutting a job, and was unable to recreate the nest as I hadn't recorded the sizes the sheets I'd initially added (and had since cut).