Thermwood / eCabinet Systems

I'm also using the SB LInk, and have had the same issue that Gary notes.

Thanks Kerry.

I should know this by now, but how do I rotate the cabinet?

Is there a way to do this, using a concealed hinge? My guess would be that it would involve rotating the cabinet 90 degrees, onto it's side, but I wasn't sure if this could be done.

-Thanks.

Just what I was after. Thanks Paul.

Is there any way to resize the selected view so that fills more of the page?

Also, is there a way to hide interior parts (shelves), concealed hinge holes etc?

Thanks.

Thanks Kerry. I'll work on it later on, and see how I make out. -Nat

I've only just started using this area of the software. I'm generally just trying to apply outside dimensions to my cabinets from an elevation view. It seems, in order to pick the correct corners of each dimension, I need to zoom in virtually on each cabinet. When I pick the two ends for the dimensi...

I drew a 1/2" w x 1" tall rectangle in the Shape Mangager, centered on the Y axis, and assigned it to a 3/8" bit., whcih seems to be working. Is this the proper way to go about it?

Am I able to set up a 3/8" bit to cut 1/4" wide rabbits on the edge of a part? If so, I wasn't clear on how to approach this in the shape manager. Thanks.

I'm not sure this is the best place to post this, and I'd guess I've missed the window for Ver 6., but at some point, would it possible to add this option to the software? If it turns out that there's the option in V.6 to do Part Editor cuts to drawer boxes, I think the only other step required woul...

Thanks Roger. I had never looked into that tab, but just did, and it does just what I'm looking to do.

Thanks, Nick. I'll give that a try tomorrow, when I can check my actual material thickness. -Nat

When I change a material thickness, then open and re-save a job, will the cabinets automatically adjust for the new material thickness? Or do I need to open each cabinet in the the CE and allow them to regenerate individually?

Nick,

You're right, I was specifying single faced material, and changing that did the trick. Thanks for the help.