Search found 36 matches

by Jason Stephenson
Tue, Nov 02 2010, 3:10PM
Forum: Thermwood 3-Axis Machinery
Topic: problem with air pressure
Replies: 5
Views: 4217

Re: problem with air pressure

I have already cleaned all the tools and the router aswell, i just done a tool lockout and tried to manually remive the tool and it seem to take ages to eject and now i have the problem that i can't get the tool back in! also when we were cutting out yesterday we would cut 1 sheet then lift the shee...
by Jason Stephenson
Tue, Nov 02 2010, 1:01AM
Forum: eCabinet Systems Software
Topic: cutting a corner cup out
Replies: 1
Views: 1880

cutting a corner cup out

HI I have a corner cupboard that is 1475 x 1475 with a back corner inset of 900 mm was just wondering if there was a way to check that the deck width is 560mm deep! and also was wondering how to nest it in to 3600mm x 1200mm sheet it nest into a 2400 x 1800 and was just wondering whether you could d...
by Jason Stephenson
Mon, Nov 01 2010, 11:51PM
Forum: Thermwood 3-Axis Machinery
Topic: problem with air pressure
Replies: 5
Views: 4217

problem with air pressure

Hi Having a big problem with air pressure, the gauges all show that air pressure is up at 100 psi but when it goes to change a tool it takes about 15 seconds to eject the tool but when it puts the next tool in it only takes a few seconds to grab. to me it sounds like there is a sensing problem somew...
by Jason Stephenson
Fri, Oct 01 2010, 12:30AM
Forum: eCabinet Systems Software
Topic: shlelf on angle
Replies: 1
Views: 1544

shlelf on angle

hi just got a question we r making a cabinet with the shelf on a 30 degrees that runs up just wondering whether there was a way to do this or not we blind dado our shelves into the left and right ends thanks jason
by Jason Stephenson
Tue, Sep 14 2010, 11:20PM
Forum: Thermwood 3-Axis Machinery
Topic: Offfalls cutting into parts
Replies: 5
Views: 2767

Re: Offfalls cutting into parts

We are having the same problem with our off falls aswell what we have done have just got no offfalls when we nest! we have been informed that they are working on fixing it!
Jason
by Jason Stephenson
Sun, Sep 12 2010, 8:53PM
Forum: eCabinet Systems Software
Topic: Draw height clearance dissapers
Replies: 1
Views: 1571

Draw height clearance dissapers

I have Just came across a problem with the draw front height when we put a set of draw fronts on a cabinet we allow 4mm clearance a the top and draw to draw gap is 2mm on ecabs,then when we cut out the draw front and screw them on with the bottom draw front flush with the deck then a 2mm clearence b...

Go to advanced search