Thermwood / eCabinet Systems

Tabatha

In the cabinet/assembly editor go to the door/drawer editor. On the left you will see the last button on the upper section is add/Locate pulls...this will allow you to place them anywhere on the door you would like

Mark

On my uppers, I always add the first shelf with shelf holes - leaving no holes below and adding 20 +/- above depending on the size of the cabinet. Then I place the shelf 1.25\" from the deck. Balance of shelves, if any, are then placed without holes.

Is that what your looking for...?

Very nice Peter...I especially like the attention to detail throughout the casework.

Is this a job your are building, is so I'm sure Jason would be interested in seeing it and photos of the completed piece.

Mark

Thanx Micheal...I'll keep it in mind for the next zoo keeper wanting cherry traveling cases...

Dan - you're right...no & no here is the cabinet

Okay...now get this

the illustration shows the holes on the outside of the cabinet, with the dados being correct on the inside of the cabinet.

When I nest the cabinet (in ecabinets and/or on the router) the dado's show up as the flip op - not the holes.

Thanks Dan....that's what I needed was someone to put a smile on my face today!

But truly - after I made the post earlier...I did think since it does have a cabinet on that side I would just make sure the depth of the holes went all the way through the material

I know from reading various posts that we've had some problems with shelf holes...this is one I ran across this morning.

For some reason it is only the right side that has the holes on the wrong side of the sheet. Dados are correct

Any help out there or is this one for the list?

Thanks
Mark

Rick...could you not take that part into the part editor and cut it down to the 1/4\"?

Mark

Looks really nice Mike - can't wait to see the rest of the pieces....

Mark

Ernest...the bookcase looks very nice.

There is a lot of satisfaction in that first piece and as you use the software it will only increase....soon you'll be wanting a Thermwood router too!

congrats!

Mark

hey Bill...I recieved mine over a week ago....

it should be there any day now!

I think Michael may have been right with the air pressure - however I don't understand why it's so random... Forest the tools aren't really popping or pushing through...they aren't actually seating into the holder, because as soon as the arm moves back out into position and gantry starts to move the...

I'm having a problem with my typewriter tool changer...several months ago we started having a problem where the toolholder in the #2 position would not seat properly after a tool change and would fall out on the table or worse the floor. In assessing the problem at that time we found the toolholder ...

Hey Craig

go to http://www.ecabinetsystems.com home page and look for production sharing on the left hand menu. If you follow that you will find a world map. Click on the area you are interested in visiting and it will list those people who have posted their services.

Mark

I added $500 for design to the price...so I can't say that I charged for all my time as I'm still on a reasonably steep learning curve with trying to take ecabinets a bit beyond simply designing \"boxes\". I worked most of the weekend to put is all together...I'm sure Dan or one of the Mik...