Thermwood / eCabinet Systems

I cut alot of MDF here in the shop and have little problem doing so. I would have to wonder if your dust collection is sufficient enough or maybe has a restriction cuttin down the cfm's. Just a thought.

Thanks kerry, I was hoping I could save the geometry as a dxf file but now that I think about it, that has been covered to prevent people from saving as a dxf and cutting on competitor machines.

Thanks again,

Damon

Its been a while since I tried this but I thought you could take a part into the parts editor and create your geometry and then save the geometry as a dxf file. I can only get a x_t extention to show up.
Maybe I dreamed this.

Thanks,
Damon

as others have stated, the MDF grade makes a big difference and you might adjust your step over. A smaller step over will take a little longer but will produce a better end result. I am assuming you are using the profile modeler.

Kerry, I looked at the 41 when I purchased my 45. There are limitations to the 41. It runs a little slower, you are limited to the 4x8 table, and you can not use the rotary play back with the 41 and I am wanting to say that there are fewer tool holder positions. Are you thinking about getting into a...

One thing to remember on thinner material. If you are placing shelf pin holes on both sides and wish to have your shelving level across the cabinet. The length of the pins may interfere with each other. I try to stay with 3/4" for center partitions to avoid this problem.

Never Mind, Thermwood came to the rescue again. Thanks

Somebody want to take a look at this problem. The back left tenon has a chamfer cut rather than a tenon and the right tenon on the Back is wireframed. If I change the back left to BUTT is correct the right side. What the flip is going on now?

Thanks,

No problem, Glad I was able to help.

Here is your cabinet with edgebanding. You need to open the construction settings and set the deck , front edge to Butt . You will notice the area is blank.

can you post the cabinet so we can take a look at it?

just set a bottom offset on the style for the upper cabinet so that they extend down the length of the lower cabinet.

We now offer an extensive body of cabinet and furniture libraries and carving files that are all available free. Ken, That's great that you now offer these features for free. I just wish your salesman that called me about six weeks ago and asked if I would be interested in purchasing those carvings...

Mine did that with the last update. It screwed up one of the files. I forget now which one but if you call THM they can tell you which one you need to erase and your maintenance will start working again.

Today's Inspirational Message




Never piss off a guy that owns a backhoe