Thermwood / eCabinet Systems

Tom,

some of this will help and speed up proces, but ther is ways to go around them!

Virtual PC is fine, but it's better to have seperate hard drive and dual boot. It,s much faster like that!

I am talking about ALL UPPER cabinets!
What i do is but top into thye back, and dado back into the deck and there is no problem!

Lawrence,

try to uninstalln eCabs, and install it again. The error is maybe deeper than update file!

Steve,

there is still no files!!!

Sebastien,

what i did to eliminate that is make the top and deck of the cabinet different shapes and/or dados, so top only fits on top, and deck only fits on deck and there can be no mestake!

I think i found it and it should be on it's way now!

Thank you, i will try that!

Todd, I am trying to keep the darwer front the same while the i shrink the seed cabinet. If the cabinet is 34.5 inches high and the drawer front is 6, when i shrink it to 32.5, the drawer front shrinks too. Well, i need the drawer front to stay the same, because all cabinets that we make here at AMS...

I just have a quick question.
Would it be helpfull if CM was not limited to only edited parts in PE?
I know that this would help me a lot.

Rolf,

did you try using blind dado drower boxes???

Not a problem.

Plese let me know how it works out for you.

I agree with you too.

I mean, every program has it's bugs and to be good at it one has to learn how to work around them!!!

Mark, make sure that you have .5, .375, and .25 bits set up at the router. For some reason router has a problem with the G-code if there is no tools with that exact diametar. The same thing was happening to me and as i would scrole down to the part of the code with the problem it would say that the ...

Brent,

what Joe ment to say is .dxf file.