Thermwood / eCabinet Systems

FYI, here are the Travaini numbers for all the parts needed for maintenance.

680-1220-C000 Separator element (1) on the system
601-0100-A003 Filter silencer element (2) on the system
601-0570-A003 Inlet filter element (1) on the system
971-0022-A005 Dynalube 5 gal (17) gallons in the system

Anyone know the Air/Oil Separator part number for the Travaini 40hp TRO 500S-1A? I cannot find any information online and Travaini hasn't gotten back with me yet.

Thanks, Forrest

Unfortunately Will it can't be done until they give us the option to make part edits on doors and save them off to a library so they can be applied on a global level. Been asking for that for well over 10 years. What I've been doing is taking my door list and create a batch file in the same job usin...

I'm still running Windows 2k without issues so I would assume W7 will be fine.

Forrest

Terry, I would second what Clint said about taking more although we only take .0625" or 1/16". I've found that sometimes the sheet is undersized to 48 7/16" so even the 1/16" trim just barely touches it.

Forrest

You have to start the program from the beginning and go through the wasteboard setting as well as pop the pins up. Should be on a "pins down" (M62L8 on my machine) command. Do a line search to the sheet you want to cut on, start at the same "pins down" line of code to get the she...

You can restart the sheet as usual and after it starts rapid moving block stop and search for your outline tool. Push start on that tool and it should give you a prompt of "do you wish to start on this line". Just say yes and it will start doing the outline again. Make sure when starting t...

I've done a fair amount of that type cutting and have best results with a 3 flute rougher hogger upshear purchased from Carolina Specialty Tool $275. By a shorter one if you can with less cutting edge. Set the tool as far into the collet without the fluting touching. I usually leave mine an 1/8"...

It would help tremendously if the dado stopped short of the back edge.

Forrest

I had issues years ago and was told it looked for the best tool starting from #1. Putting it first in line helped. My understanding is it's supposed to look for the largest pocketing tool available but I never strayed from making sure it was first in line too.

I set up the same tool# as my outline tool as only pocket box checked and make sure its before all other pocketing tools.

As a second note, it will not use more than 3gb of ram because it's a 32bit program. Still, you have a very capable computer.

I would suggest checking for a video card update first. Also, if its crashing going from LDE to CL I would save it while still in LDE.

Forrest

Hi David, you can take a single cabinet into LDE and rotate it 90 degrees. You can even select a side and hide it so as to see the internals.

Hope that helps, Forrest

Maybe something to do with the ramp in settings?

Forrest

Hi Carmen, it would be nice if the printer setup is in the drop down menu on every sheet since on any given job there may be multiple setups.

Forrest