Thermwood / eCabinet Systems

Thanks Dan, It worked great.

I think I know the answer to this (no) but incase I'm missing something - can this be done with e-cabs? I need to make a cabinet with an inside curved arched door. I'm attaching files of what I've got so far. These are not to the scale I need just trying to see if it can be done. I applied the curve...

Thanks Dan, will do.

I've searched and can't seem to come up with the answer to my problem. The attached file shows a cab with a center partion and a shelf on one side. the left side is longer than the right and I can angle those - it's the partition and shelf that are giving me fits. Any help will be appreciated. There...

I have drawn one that looks similar to that in e-cabs and cut it perfectly. It'll be a piece of cake.

Thanks Kerry.

I've just got a greyhound type bus to do all the cabs and trim. Should be fun. I need almost all the cabs to have angled fronts. I can't seem to get my FF's and Doors to follow the angle. Any help will be appreciated.

I have a profile on each end of this block & get an error message in the profile modler of no data. I took the champher off the end and it works fine. cut the pieces and put the champher on with the jointer. Just wondering why I can't machine both ends.
Thanks

I should have said that this is in the profile modler.

I made a bunch of base a door top molding for a job and ran short. On the original batch I had the step over set at .02 and didn't want to sand the piece that I was short so I set the step over to .01. That works wonderfull no sanding to speak of and it doesn't take that much loneger. Well worth the...

Thanks Brian,

I didn't want to have to do all the geometry, etc. over again so I just put a small offset (ended up the smallest it would take is .151) and it works fine. These doors are clear away from any of the originals so that small amount of difference will not be noticable.

Thanks again.

I have some arched door that have \"plastic glass\" (real ugly) in them that the folks want to put wood inserts in (like the rest of the doors). No problem, I'll draw them up and cut them out. When I try to profile the edge I get an \"internal algerithum error\". Doesn't matter w...

Chris. I have the fixture and have made 60+ doors now. It's a dream compared to the table saw and router.

I'll do it!!! I thought only cubes didn't nest. Learn something every day.

Thanks

Here is a board that will be the front of a trash bin. I used a DXF file to get the letters and did the rest in the part editor. Every thing looks good but it won't pull up in control nesting. Any suggestions?

I've ziped and attached the .twd -.dxf and .esa files.