Thermwood / eCabinet Systems

The build direction of the walll is right, once the cabinet is through the wall it won't go back through the non-build side, ya gotta carry it through a doorway, and some of these cabinets are heavy.

While working in custom layout, when placing cabinets in the room with place mode set to Aligh To Back, cabinets go through the walls, not butting right up to the wall. I'm using V6B3, haven't tried another job yet to see if it's consistant

So, if I bump up to a better graphics card (I'm going by the recomendations) and you folks change the program again, is it going to be good enough in the long haul? I upgraded the cpu a year ago to run the program, V5 ran great, V6 B1,B2,B3............not so much, so I want to make sure I don't unde...

Attached is a cabinet that this problem occurs on, I take any cabinet, one I have already created or a standard cabinet, go to door/draw editor, set a default hinge, add door(s), check cabinet buy list, hinges show up as 0, in cost sheet hinges are non-existant, slides & mounts show up.

V6B3 sloows to a crawl for me too, got to save after every edit because there are times it's just best to shut down & re-open program, and yeah, the more edits the slower it gets

Just started a new design in V6B3 and when I add doors to a cabinet the default hinges don't show up in th cost sheet, they appear in the cabinet buy list but as a quantity of zero. If you manually add the hinges & update quantities they then come into play, seems the should be there when you ad...

Just started working on a new project in build 3. Program still runs slow & freezes up when in layout editor, best thing to do is shut 'er down & start over, the job doesn't contain a whole lot of detail

I just started designing some cabinets in V6B3, when adding doors the hinges are not being applied to the cabinet buy list or cabinet cost sheet. Door bumpers and shelf clips are, what's up with that?

I get the same thing, much preferred the right click option to load items

Ryan, attached is one of the jobs with slow down. So far any job I work on acts the same, the more you edit, the slower it gets

There now is a cabinet buy list at the bottom of the options drop down, you have to enter all your hardware options to choose from

I too am experiencing slow response in v6b2. When associating a cab to a wall it takes about 40 seconds to be able to do anything else on the program. I can edit 1 cabinet and save in around the same amount of time, go to a second cabinet and the time goes to around 2-2 1/2 minutes, try a third and ...

I am still missing cabinet parts (mid rails, bottom rails, the tops of top rails, door parts) in the print and print previews in lde, at least now the cabinets are on the right side of the wall again, and not jumbled up. Is there any way to go back to V5.2, what used to take me 45 minutes now takes ...

My cost sheets come up with most hinges and some drawer slides missing, haven't gone through the sheet/board stock manually to see if that's an issue

I came across the same problem, also cabinets would be shown inside out and with parts (stiles, rails, doors) missing or in the wrong places. Have to make a pdf and print that, and that isn't always the best format, uses more ink on my computer.