Page 1 of 1

angled front cabinet

Posted: Sat, Feb 23 2013, 2:34PM
by Carl Hoover
Hi Folks
Is there anyway to make a cabinet like this by entering the dimensions as opposed to adding and angling parts on an assembly.
Thanks
Carl

Re: angled front cabinet

Posted: Sat, Feb 23 2013, 3:37PM
by Scott Marshburn
Carl you would probably get more responses if you posted this in the eCabinets Software Forum. As For that type of cabinet The only way that I am aware of is to cut the angles on the parts in part editor and add a face frame from another cabinet and save it as a assembly