Page 1 of 1

mouldings

Posted: Thu, Oct 26 2006, 8:22PM
by mark l cherry
where do you guys get the thermwood mouldings for the italian renaissance credenza, all the places i look have no information on were to order,the stuff.
thanks mark

Posted: Thu, Oct 26 2006, 9:47PM
by Glenn Van Reason
I'm not totally sure, but the credenza is part of the furniture program. This means that the design is available for anyone who has a Thermwood router to download and install on their router. They can then cut out the parts necesary to buile the credenza.
So if you have a router you can purchase this file and cut them yourself, or if not you can contact a member that has a Thermwood router who could supply them to you.
Post up your location and a request to get a quote and I'm sure soemone on the board would be more than willing to help.

Posted: Thu, Oct 26 2006, 9:49PM
by Brent Bogardus
Mark,

I don't think that Thermwood sells those mouldings. The programs are available to be downloaded to a Thermwood router on a rental basis. You may be able to find someone in your area with a router who could run those for you.

Check out the production sharing section on the left hand side of the Thermwood home page to find someone in your area with a router.

Re: mouldings

Posted: Mon, Oct 30 2006, 12:47PM
by Jody Wilmes
mark l cherry wrote:where do you guys get the thermwood mouldings for the italian renaissance credenza, all the places i look have no information on were to order,the stuff.
thanks mark


The moldings are available as rental programs only. If you do not have a Thermwood machine, you may be able to find one who does, to run the rental program and cut your piece. There is an EXE which may be freely downloaded from our webstore for this piece of furniture. If the EXE is ran on a pc with eCabinets, it will install all the eCabinet files. If the EXE is ran on a machine, it will install all the rental programs, setup procedures, etc.
Hope this helps!