Place to discuss only the "Design Sharing" aspects of the eCabinet Systems software.
3 posts • Page 1 of 1
I know a lot of you offer a machining service, but is there anyone out there offers an eCabinet design service? I have a few furniture pieces I have designed but at this moment I don't have the time or the advanced knowledge to create them in eCabinet.
- Roger Erismann
- Senior Member
- Posts: 169
- Joined: Sun, Dec 04 2005, 11:42PM
- Location: Sacramento, CA and Rolla, Mo
Robert take a look at a post I just submitted in the software forum:
Wood Butcher/Case Maker
Who is online
Users browsing this forum: No registered users and 4 guests