Page 1 of 1
Can MasterCam NC files be put on the design sharing network?
Posted: Thu, Jun 14 2007, 8:25PM
by Greg Witkamp
I have a chair design that I have made in MasterCam X2 that I would like to on the design sharing network. How would I go about doing that if its possible?
Posted: Fri, Jun 15 2007, 6:35AM
by Kerry Fullington
Greg,
If you click on the Design Sharing Icon in eCabinets (the hands shaking) it will open a dialogue box where you submit your design sharing files. I think you will have to call Thermwood about submitting the MasterCam files though.
Kerry