I am working with a corner base that has a clipped back. i want a 3/4 inch piece on the clipped part of the back, but .25 plywood for the left/back and right/back.
Under construction settings there is only one place to pick the back material. Am I asking for the impossible?
Kenneth
corner base back question
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 161
- Joined: Thu, May 04 2006, 11:09AM
- Location: Southwest Houston
- Contact:
-
- Wizard Member
- Posts: 4718
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: corner base back question
[urlhttp://www.thermwood.com/forums/viewtopic.php? ... er+cabinet]THIS THREAD[/url] is a discussion about what you are trying to do . Maybe it will help.
Kerry
Kerry
-
- Senior Member
- Posts: 161
- Joined: Thu, May 04 2006, 11:09AM
- Location: Southwest Houston
- Contact:
Re: corner base back question
Thanks Kerry.
I got it changed per the instructions on the last post, but when I try to make the parts fit together in the editor, it reverts back to all the same. I think I may give up on this one and just change materials.
Kenneth
I got it changed per the instructions on the last post, but when I try to make the parts fit together in the editor, it reverts back to all the same. I think I may give up on this one and just change materials.
Kenneth