Part editor cuts on dbx - cant resize

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

leigh mills
Senior Member
Posts: 211
Joined: Wed, Jan 23 2008, 9:49AM
Location: England UK
Contact:

Part editor cuts on dbx - cant resize

Postby leigh mills » Tue, Jan 19 2010, 9:39AM

Hi,

I have added part editor onto our Drawer boxes, now when I come to resize the unit we are getting an error. This has only started happening since I added the part editor cuts, the units resized without these cuts.

I have attached the unit, so if anyone can help out or has faced this issue can they let me know.

Cheers,

Leigh
Attachments
0140 - 5 Drawer Chest - Over.hsf
(2.4 MiB) Downloaded 41 times
0140 - 5 Drawer Chest - Over.jpg
0140 - 5 Drawer Chest - Over.jpg (14.4 KiB) Viewed 656 times

User avatar
Scott G Vaal
Thermwood Team
Posts: 1741
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: Part editor cuts on dbx - cant resize

Postby Scott G Vaal » Wed, Jan 20 2010, 3:27PM

Leigh,

Will you please verify this for me: Is the error you're getting "There was an error while adding or removing tenons for the Top Stretcher Front........" and then a message "There was some problem while regenerating the Front Top Stretcher Press YES to lose PE cuts or NO to revert to old cab"? and then the same for the back?

When you said:
the units resized without these cuts.
are you saying the drawer boxes lost the PE cuts? If I answer yes to remove PE cuts for the top str front and Back, it will resize the cab correctly and the drawer boxes will resize and keep the PE cuts on them too. Please let me know. If you are seeing what I am seeing, then I have reproduced this from scratch and will have it resolved. If you are losing PE cuts on the drawer boxes, I will need more info from you.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000

Darren Harvey
Junior Member
Posts: 68
Joined: Fri, Jun 23 2006, 9:01AM
Location: palm harbor, fl

Re: Part editor cuts on dbx - cant resize

Postby Darren Harvey » Mon, Jan 25 2010, 6:33AM

i'm also having problems with keeping PE cut on my drawer boxes. when i place a drawer box in a cabinet i get an error message saying it can not regenerate the part editor cut. i'll send my cabinet and drawer box. thanks, darren

there are going to be 5 drawers
2@ 4 3/4"
3@ 2 3/4
Attachments
paint locker rev1 dmh.hsf
(938.02 KiB) Downloaded 41 times
HS finger hole box.hsf
(348.02 KiB) Downloaded 40 times


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 17 guests