A large island with angled corners, flutes and corbels.
What is the easiest method? Would it be back to back walls and 4 angled set at the correct position. If the walls are not to be seen are they set to 0?
Corbels, flutes, onlays etc ... can some one point me in the right direction?
Thanks
Island
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 17
- Joined: Sun, Jul 01 2007, 4:06PM
- Location: San Antonio, TX
- Contact:
Island
Pete
-
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: Island
Pete,
You would probably find it easier to create an assembly of cabinets and parts in the CE, and then take that to your room layout.
You would probably find it easier to create an assembly of cabinets and parts in the CE, and then take that to your room layout.
-
- Guru Member
- Posts: 477
- Joined: Tue, May 17 2005, 1:55PM
Re: Island
Look here for parts -- http://www.thermwood.com/forums/viewforum.php?f=5 -- and also under Hardware Products and Adams Wood products.Pete Rafferty wrote:A large island with angled corners, flutes and corbels.
What is the easiest method? Would it be back to back walls and 4 angled set at the correct position. If the walls are not to be seen are they set to 0?
Corbels, flutes, onlays etc ... can some one point me in the right direction?
Thanks