Good morning all
I am designing a reception area and need to put a counter top on my wall in the corner. I am using a base cabinet full top section to add the tops with open space under. Its all good untill I use part editor to modify my full top to fit my corner ( a triangle ) to go on top of my walls. Once I edit the full top and go to counter top editor I can not select the corners, the little circle x wont show up. Any ideas or better ways to shop the tops ? Thanks Tim
counter top problem
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
counter top problem
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us
-
- Wizard Member
- Posts: 4722
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: counter top problem
Tim,
I think this is a known problem.
I reported this in the Beta Forum and here is a quote from Ryan on the issue.
I think this is a known problem.
I reported this in the Beta Forum and here is a quote from Ryan on the issue.
Yes, this is still broken. As always, we hope to have this fixed soon,
-
- Senior Member
- Posts: 161
- Joined: Thu, May 04 2006, 11:09AM
- Location: Southwest Houston
- Contact:
Re: counter top problem
For me it's usually easier to just do a large display panel and take it to the editor and cut it the way I want. For counter tops you have to have a cabinet there first. If you do that, just texture the display panel the same as your couters and you can place it anywhere you like.
Kenneth
Kenneth