When I try to Define Hardware Categories, the system creates som odd looking subfolders are follows:
C:\Documents and Settings\All Users\Documents\Thermwood\eCabinet Systems\hardware\user created\100C_6A02_400D_852C_BA3D
C:\Documents and Settings\All Users\Documents\Thermwood\eCabinet Systems\hardware\user created\326F_BD01_4FC1_9495_07E0
C:\Documents and Settings\All Users\Documents\Thermwood\eCabinet Systems\hardware\user created\651A_01D2_4241_8158_629F
Now when you are in the hardware catalogue editor the categories are listed as the names that I elected.
Then I create a new hardware part called ADJ-LEG and save it into a new category I just created.
After I try to select the new piece of hardware and associate it with a cabinet,two problems emerge:
a) The names of the new category are not displayed in the selection pane (see diagram)
b) The ADJ-LEG that I created can't be located
Any ideas anyone?
Defining Hardware Categories
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 75
- Joined: Tue, Feb 16 2010, 2:39PM
- Company Name: Sean Jakob Cabinets