Part Editor cuts are returned erroneous when crossing tenon dados. Steps to repeat:
From CE, open std base framed
Const set. >>GLobal set joinery to blind dado
>> Uncheck Face frames
CE main
Part/shelf editor>> remove adj shelf
> add fixed shelf rear setback 16, set opening hgt to 5
> add partition in opening formed by shelf
CE Main
take partition to PE and make rectangular thru cut on top edge
CE Main
Take partition to Const Mgr>> constrain parts
Returns this part:
Taking cabinet to nest returns similar part. Which seems to make a pocket rectangle inside the tenon dado, instead of becoming a portion of the part outline.
V6b2 Part Editor
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 256
- Joined: Sat, Apr 04 2009, 6:27PM
- Company Name: ShopBot Tools Inc
- Country: UNITED STATES
- Location: Durham NC
V6b2 Part Editor
Gary Campbell
ShopBot Tools Production Support
ShopBot (eCabinets) Link Training & Support
ShopBot Tools Production Support
ShopBot (eCabinets) Link Training & Support
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: V6b2 Part Editor
Gary,
This is not new behavior to V6 build 2. This cut away tenon returning across after a regen has always done this from the birth of the Part Editor. You must have just not seen/performed this specific scenario before. Some time in the future, we hope to be able to support the system tenons being split.
This is not new behavior to V6 build 2. This cut away tenon returning across after a regen has always done this from the birth of the Part Editor. You must have just not seen/performed this specific scenario before. Some time in the future, we hope to be able to support the system tenons being split.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000