When I try to load the attached corner cabinet (which was created in version 4 or 5) directly into the cabinet editor via the load screen, eCabinets hangs at the “Applying Part Editor / Constraint Data” step.
If I load the cabinet into a batch cabinet list or into a room layout, then click on the cabinet to take it into the cabinet editor, it loads OK, but I'll be buggered if I can get to too load direct from item menu into cabinet editor.
any suggestions anyone?
Version 6 Build 2 – Can’t Open Corner Cabinet
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 75
- Joined: Tue, Feb 16 2010, 2:39PM
- Company Name: Sean Jakob Cabinets
Version 6 Build 2 – Can’t Open Corner Cabinet
- Attachments
-
- Corner Cabinet.hsf
- Corner Cabinet Won't Load
- (1.15 MiB) Downloaded 243 times
-
- Wizard Member
- Posts: 4722
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: Version 6 Build 2 – Can’t Open Corner Cabinet
Sean,
Sean,
I placed your cabinet in a room and took it to the cab editor from there, opened construction settings then exited construction settings to re-generate the cabinet. (this took a while) I then saved the cabinet from here, closed out the room and I can now open your cabinet fine in the cabinet editor.
Kerry
Sean,
I placed your cabinet in a room and took it to the cab editor from there, opened construction settings then exited construction settings to re-generate the cabinet. (this took a while) I then saved the cabinet from here, closed out the room and I can now open your cabinet fine in the cabinet editor.
Kerry
-
- Junior Member
- Posts: 75
- Joined: Tue, Feb 16 2010, 2:39PM
- Company Name: Sean Jakob Cabinets
Re: Version 6 Build 2 – Can’t Open Corner Cabinet
Kerry
Thank you for taking the time to have a look at it for me
Sean
Thank you for taking the time to have a look at it for me
Sean