Part Editor Changing Part sizes

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Samuel Mayer
New Member
Posts: 3
Joined: Tue, May 13 2008, 11:22AM

Part Editor Changing Part sizes

Postby Samuel Mayer » Thu, May 06 2010, 4:14PM

Well, I have a upper face frame cabinet with glass doors on front and side! Sometimes when I cut the side out the appropriate size for glass door, the part size will change after! I can go back to C.E. looks great! Return to room then back to same cabinet and my side "seems" as though it has a negative front inset of 1/4", and my cutout location has changed? I did not change size or can find any reason this would happen? Could it be there is a glitch in part editor? It hasn't given me any problems with anything else??

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 13 guests