Please load attached job and note size of doors in batch. Bringing to cabinet editor confirms size is correct (on my end anyhow)
Nest - and note the size of the doors in the nest.
Unfortunately I did not realize this until the doors were already machined....
Can anyone else reproduce this error and of course I need to make them the right size, so any help would be greatly appreciated!
1 post • Page 1 of 1
- Josh Rayburn
- eCabinets Beta Tester
- Posts: 1262
- Joined: Wed, Jul 01 2009, 2:19PM
- Company Name: Halls Edge Inc
- Country: UNITED STATES
- Location: Stamford, CT USA
Who is online
Users browsing this forum: No registered users and 12 guests