Funny thing happened ....

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Donald Thomson
Guru Member
Posts: 750
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Funny thing happened ....

Postby Donald Thomson » Thu, Apr 07 2011, 3:18PM

When cutting this corner cabinet, a strange thing happened. One mortise didn't get cut. All the other mortises along with their matching tenons were cut. I've attached the cabinet along with pictures of the cutting results. This was all done using ShopBot Link.

Anyone have some insight into this?

Thanks!
Attachments
Seed - Corner faceframe - 3 drawer.hsf
Cabinet file
(1018.02 KiB) Downloaded 133 times
Missing mortise 1.jpg
Tenon and OOPS no mortise
Missing mortise 2.jpg
Mortise and matching tenon ok
Missing mortise 3.jpg
Both panels showing the missing mortise
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com

Kenneth Rychlik
Senior Member
Posts: 161
Joined: Thu, May 04 2006, 11:09AM
Location: Southwest Houston
Contact:

Re: Funny thing happened ....

Postby Kenneth Rychlik » Fri, Apr 08 2011, 10:59AM

Don, I tried it and it doesn't put the dado on there within ecabs when you nest from there, so I don't think the link has anything to do with it.

Kenneth

Donald Thomson
Guru Member
Posts: 750
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Re: Funny thing happened ....

Postby Donald Thomson » Fri, Apr 08 2011, 11:02AM

Thanks Kenneth.

I'm not sure what eCabs has against this particular mortise. Maybe Ryan can check in here?
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com

User avatar
Scott G Vaal
Thermwood Team
Posts: 1740
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: Funny thing happened ....

Postby Scott G Vaal » Mon, Apr 11 2011, 4:07PM

Don,

I have tracked this issue down to face frame (left and right stile) outside scribes existing with corner stretcher tops. If you remove the scribes, the dado will then get created. If you can live without the scribes for now, you can get the dado to cut. I will get this listed and resolved. Sorry for the inconvenience.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000

Donald Thomson
Guru Member
Posts: 750
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Re: Funny thing happened ....

Postby Donald Thomson » Mon, Apr 11 2011, 7:55PM

Thanks Scott!
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 9 guests