hardware
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Ronald ODett
- New Member
- Posts: 6
- Joined: Mon, Nov 29 2010, 6:34PM
- Company Name: R+R Classic Wood Work
hardware
Could someone please help me to find hardware,[ pulls,knobs, etc. ] to use in ecabs, since ecabs does not have source in program? Thank-You in advance,Ron
-
Scott G Vaal
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: hardware
Ron,
You can download pulls from our website. They are on the same page as the install/update file. Go to {member services}, {software install/updates}. scroll down a little and you should see some additional install files you can download. I recommend using the (low quality - high performance) set especially if you would have a weaker system. They look good at your typical distances and will not be as taxing on the PC.
You can download pulls from our website. They are on the same page as the install/update file. Go to {member services}, {software install/updates}. scroll down a little and you should see some additional install files you can download. I recommend using the (low quality - high performance) set especially if you would have a weaker system. They look good at your typical distances and will not be as taxing on the PC.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000