Scott,
The Amana tool you specified works for me also.
The 1/4" tool I have attached gives me the Unable to Perform Sweep Operation error when I try a partial operation.
Problem Profiling!!!!
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Wizard Member
- Posts: 4723
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: Problem Profiling!!!!
- Attachments
-
- Quarter_Inch_Flute.zip
- (4.2 KiB) Downloaded 267 times
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: Problem Profiling!!!!
Kerry,
Hmmmmm, I cannot seem to get this tool to do a partial or a full chain. I assume you are using the cabinet named {Base} that is made out of a cabinet back? Where on the part do you start your chain or partial chain?
Hmmmmm, I cannot seem to get this tool to do a partial or a full chain. I assume you are using the cabinet named {Base} that is made out of a cabinet back? Where on the part do you start your chain or partial chain?
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
-
- Wizard Member
- Posts: 4723
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: Problem Profiling!!!!
Scott,
I am using the part named Base created from a beck
Here is the starting point and direction for a chain which works for me
and here is the starting point and direction fro the partial which does not work
I am using the part named Base created from a beck
Here is the starting point and direction for a chain which works for me
and here is the starting point and direction fro the partial which does not work
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: Problem Profiling!!!!
Kerry,
Thanks for the info. I figured out that if I do the full chain first thing, it will work as you said. However, if I do a partial first, get the failure message, then it will not do a chain from that point on until I return out and then bring the part back to the PE. I added this info to the listed issue. Thanks for your help.
Thanks for the info. I figured out that if I do the full chain first thing, it will work as you said. However, if I do a partial first, get the failure message, then it will not do a chain from that point on until I return out and then bring the part back to the PE. I added this info to the listed issue. Thanks for your help.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000