Is there a way to make the miters miters on the backs of the corner cabinet a 45 degree instead of a 22 1/2? My guys don't like the 22 and are insisting I make the back a full overlay with a 45 on the side backs.
Thanks for any help.
Corner Cabinet Back
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 27
- Joined: Thu, Jan 26 2012, 9:36AM
- Company Name: Zimmerman Furniture Co
- Country: UNITED STATES
-
- Guru Member
- Posts: 837
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
- Contact:
Re: Corner Cabinet Back
Are you cutting out your parts by hand if so you could change the corner gap to 0 and check miter 90 deg. Corner. This would give you plenty to cut the 45s you are after.
I cant see any way to make the miters change and cant seem to extend the left and right backs in the correct direction to allow enough to make them 45s
I cant see any way to make the miters change and cant seem to extend the left and right backs in the correct direction to allow enough to make them 45s
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467