corner cabinet problem

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Alex Bowler
Junior Member
Posts: 60
Joined: Mon, Mar 26 2012, 10:40PM
Company Name: cutshop
Country: NEW ZEALAND

corner cabinet problem

Postby Alex Bowler » Wed, Jun 27 2012, 9:25PM

Hi i am have a problem with this corner cabinet attached. Using part editor i applied two bi folding hinge patterns
and when i nest the cabinet the holes for the bi folding hinge randomly move of the door.
Attachments
Cab2.jpg
Cab2.jpg (9.47 KiB) Viewed 480 times
Cab2.hsf
(728.02 KiB) Downloaded 45 times

User avatar
Scott G Vaal
Thermwood Team
Posts: 1741
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: corner cabinet problem

Postby Scott G Vaal » Thu, Jun 28 2012, 7:58AM

Alex Bowler wrote:Hi i am have a problem with this corner cabinet attached. Using part editor i applied two bi folding hinge patterns
and when i nest the cabinet the holes for the bi folding hinge randomly move of the door.


Alex,

I investigated this morning and it appears that if you regenerate the cabinet (go to construction settings and then select OK) all will then work correctly. The issue seems to be adding part editor cuts to slab doors on corner cabinets. I will get this listed and resolved, but for now (and this is only on corner cabinets), just do a regeneration one time after any PE cuts on doors and it will then work just fine. I checked this in V6B7 and it does the exact same thing, so it is not new to V6B8. Sorry for the inconvenience.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 8 guests