Hi i am have a problem with this corner cabinet attached. Using part editor i applied two bi folding hinge patterns
and when i nest the cabinet the holes for the bi folding hinge randomly move of the door.
corner cabinet problem
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 60
- Joined: Mon, Mar 26 2012, 10:40PM
- Company Name: cutshop
- Country: NEW ZEALAND
corner cabinet problem
- Attachments
-
- Cab2.jpg (9.47 KiB) Viewed 2334 times
-
- Cab2.hsf
- (728.02 KiB) Downloaded 252 times
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: corner cabinet problem
Alex,Alex Bowler wrote:Hi i am have a problem with this corner cabinet attached. Using part editor i applied two bi folding hinge patterns
and when i nest the cabinet the holes for the bi folding hinge randomly move of the door.
I investigated this morning and it appears that if you regenerate the cabinet (go to construction settings and then select OK) all will then work correctly. The issue seems to be adding part editor cuts to slab doors on corner cabinets. I will get this listed and resolved, but for now (and this is only on corner cabinets), just do a regeneration one time after any PE cuts on doors and it will then work just fine. I checked this in V6B7 and it does the exact same thing, so it is not new to V6B8. Sorry for the inconvenience.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000