Drawer box finger cut out.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Greg Haw
New Member
Posts: 17
Joined: Sun, Dec 10 2006, 6:50PM

Drawer box finger cut out.

Postby Greg Haw » Thu, Jul 19 2012, 8:03PM

Been trying to make a finger pull cut out in a drawer box front. Used a rectangle and a half circle on either side of it in Partr Editor to make the cut out. When I try to add the drawer box to cabinet I get a message that says "Drawer box cannot be regenerated. Press Yes to remove part editer cuts or No to remove drawer box. Now I have tried this with just the rectangle and same thing. I tried it with a circle cut out, and it will place the drawer box in the cabinet. Oh I am doing this in Drawer Box Designer. It works if I add boxes and then make cut outs. But I have a bunch of different size cabinets I have to do this in with multiple drawers. I don't want to make individual cuts in each drawer. Is there a solution to this? And while here When I did use the circle I could not figure how to force it to stay centered in Constraint Manager.
Greg

User avatar
Scott G Vaal
Thermwood Team
Posts: 1741
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: Drawer box finger cut out.

Postby Scott G Vaal » Fri, Jul 20 2012, 8:14AM

Greg,

Attach the cabinet that has this drawer box set as default (the one you are having trouble with) and I will look into what might be going on.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000

Greg Haw
New Member
Posts: 17
Joined: Sun, Dec 10 2006, 6:50PM

Re: Drawer box finger cut out.

Postby Greg Haw » Fri, Jul 20 2012, 9:17PM

drawer unit.hsf
(2.5 MiB) Downloaded 72 times
Ok took me awhile to find where the files are stored. Xp was so much easier. Well since it don't let me install the drawer with Part Editor cuts I am not sure if this helps. But Thanks Greg!

Rick Deskins
Thermwood Team
Posts: 828
Joined: Tue, May 17 2005, 12:47PM
Company Name: Thermwood
Country: UNITED STATES
Location: Thermwood

Re: Drawer box finger cut out.

Postby Rick Deskins » Sat, Jul 21 2012, 7:24AM

To keep the finger pull the right size and place with resizing you have to use the Constraint Manager.

CM.jpg
Rick Deskins
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Google [Bot] and 4 guests