I did a print out of the nest at my house. Off the laptop to the desktop by means of wireless router and then to a wireless printer. The job spooled and printed fast.
At the office my situation is a bit different, I have a few programs that I use on my laptop that I print to my shop printer.
The computer is Win 98 and runs on a pentium 4 500MHz. When I print from my laptop there is always a slight delay, but printing this nest is a little bit on the long side.
I started at 1:54 and it is still spooling. I am using a wireless router that has a great signal and is transmitting at 54 MBs
What can possibly be the holdup. I can see the progress go up by about 55KB every few minutes, that's right, minutes.
Well as I was typing this it finally finished up spooling, 1 MB of data transferred in 35 minutes. What the heck.
1 post • Page 1 of 1
- Guru Member
- Posts: 589
- Joined: Tue, Jan 16 2007, 7:56PM
- Company Name: LRG WoodCrafting
- Location: Windsor Locks, CT
Who is online
Users browsing this forum: No registered users and 17 guests