Importing .DXF in Contour mgr

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Wayne Adelkopf
Junior Member
Posts: 45
Joined: Sat, Nov 28 2009, 8:19AM
Company Name: Noble Woodworks Inc.

Importing .DXF in Contour mgr

Post by Wayne Adelkopf »

When I go to open .DXF files into Contour Mgr., I get the following error;
"The unregistered version is for evaluation only
Purchase at www.cadsofttools.com.

Has anyone encountered this? What is the solution?
Rick Palechuk
Wizard Member
Posts: 1896
Joined: Wed, May 18 2005, 7:54PM
Company Name: Milltech Millworks Ltd.
Country: CANADA
Location: Edmonton, Alberta
Contact:

Re: Importing .DXF in Contour mgr

Post by Rick Palechuk »

Hey Wayne, can you zip and and post the DXF, and I will see what it does for me.
Wayne Adelkopf
Junior Member
Posts: 45
Joined: Sat, Nov 28 2009, 8:19AM
Company Name: Noble Woodworks Inc.

Re: Importing .DXF in Contour mgr

Post by Wayne Adelkopf »

Rick Palechuk
Wizard Member
Posts: 1896
Joined: Wed, May 18 2005, 7:54PM
Company Name: Milltech Millworks Ltd.
Country: CANADA
Location: Edmonton, Alberta
Contact:

Re: Importing .DXF in Contour mgr

Post by Rick Palechuk »

I saved it as an older version of cad (R12), that converts the Spline to Pline, it works, slow going in the PE. HTH
Attachments
Elipse 2.jpg
ELIPSE2-94X26.zip
(19.89 KiB) Downloaded 383 times
Wayne Adelkopf
Junior Member
Posts: 45
Joined: Sat, Nov 28 2009, 8:19AM
Company Name: Noble Woodworks Inc.

Re: Importing .DXF in Contour mgr

Post by Wayne Adelkopf »

Thanks Rick.
Post Reply